Microphone Distribution Amplifier

Microphone Distribution Amplifier - 1 X 3 Mic Distribution Amp (XLR with Phantom)

* XLR In/Out Microphone Distribution Amp
* Gain Trim on Input
* Stand Alone or Rack-Mountable Mic DA
* Front or Rear Panel Input
* Selectable Phantom on Input
* RF Filtered Inputs
* 1/3 Rack, High-Density Rack Mounting

Voltage: 24 VDC
Amperage: 35 mA

Dimensions: @ 5-3/4" L X 2" W X 1-5/8" H

Input Connector: XLR (3-pin)
Input Source Impedance: 150 to 600 ohm balanced; 5 ohm unbalanced
Output Connectors: XLR (3-pin)
Output Impedance: 150 ohm balanced
Gain: -5 dB to +15 dB (front-panel adjustable)
Frequency Response: 25 Hz to kHz (+/-0.5 dB)
THD+N: <0.050%
Headroom: > 18 dB
Power Requirement: 24 to 33 VDC @ 35 mA, Ground-referenced

APPLICATION: The RU-MDA3 is the ideal choice where connectorized mic-level audio distribution is needed. The input connections are also provided on the rear-panel full-sized barrier block. The outputs are 150 ohm balanced, designed to drive short or long balanced lines. Outputs are driven through XLR connectors on the front panel. When rack-mounted, a microphone signal may be hardwired into the unit inside the rack, while the three outputs are available via XLR jacks on the front. Both the front-panel input XLR connector and the rear-panel input terminals are active at all times.

Gain trim is provided on a front-panel control, accommodating a wide variety of dynamic or condenser microphones.

** Power Supply not included.

RDL RU-MDA3